Rev. 2013.08.19
9
Beverage Unit
The cans are loaded in D1, D2, D3, D4, D5 & D8. Selections D6 & D7 can be loaded with bottles.
These instructions are also available for quick reference on a yellow decal inside the unit. See Figure
9.
Figure 9 – Loading Beverage Unit
Vertical Product Column
Product Chutes
Selections D4, D5, D8
Chute #1 Vends 1
st
Chute #2 Vends 2
nd
Selections D1, D2 and D3
There are two chutes for each selection.
1. Load 2 cans only into the bottom chute.
2. Load cans into the top chute until
completely full. Upon filling top chute,
proceed to fill bottom chute, leaving one less can
in this chute. This assists with the gravity method
of vending.
Selections D4, D5 and D8
There are two chutes for each selection.
1. Load 5 cans only into the bottom chute.
2. Load cans into the top chute until completely full.
Upon filling top chute, proceed to fill bottom chute.
Selections D6 and D7
Vertical Product Columns
1.) For bottles, place cap of the first bottle against the front
of the column depressing the Sold Out Switch. Place the
second bottle to the rear of the column, touching the bottom
of the first bottle. See illustration at right.
2.) Finish loading to the top of the column, making sure
bottles are perfectly horizontal and not tilted or skewed in
the column.
3.) To adjust the rear spacer, grasp firmly and lift up and
move forward or rear, as required, so that the rear spacer is
touching the rear bottle.
Note: There are many variations of packaging among the
beverage brands. The instructions above are meant to be a
guideline. If you have packaging that isn't mentioned or
shown, experimentation will be necessary for a proper vend.
Selections D1, D2, D3
Chute #3 Vends 1
st
Chute #4 Vends 2
nd
