Rev. 2013.08.19
20
REMOVING PRODUCT TRAY
Push up the plastic cam lock lever on the right side of tray (Fig. 15). Grasp the Product tray under
both the front corners, and lift the front of the tray slightly and pull the tray out completely. Remove
the Wiring harness connecter located on the inside right-hand side of the tray.
Figure 15 – Product tray cam lock lever
(Shown with tray removed)
VEND MOTORS
Each Selection is vended by the action of the Vend Motor. The Vend Motors are screwed onto the
rear of each Product Tray. In the rare event of a jam, a Vend Motor may need to be returned to its
home position.
Figure 16 – Vend Motor
1. To “Home “ a Vend Motor
a. Unlock and open the Front Door to access the Circuit Board, and enter Service Mode
by pressing the MENUS Button
b. Cycle through the Service Mode until the Display Reads “tE”
c.
Enter the letter and number of the motor you wish to home. The motor will rotate to
its home position.
2. To Remove a Vend Motor
a. Unlock and open the front door
b. Unlock Product Tray and pull it out fully while keeping it level
c.
Lift Product tray to release from the Track and pull it out
Caution:
The Product Tray Wire Harness will need to be unplugged prior to complete removal of the
product tray. The wiring harness is plugged into the slide-out shelf in the Snack unit.
d. Remove Helix Coil from the driver by lifting the front end of the Helix Coil up with
one hand pinching the lugs of the shaft. Push the shaft through the back of the vend
motor, freeing up the helix coil/driver/shaft assembly for removal.
Note:
This operation is more difficult with smaller Helix Coils.
e. Remove the two Phillips head screws that are securing the motor to the product tray.
f. Disconnect Wires of the Vend Motor, paying close attention to the orientation of the
motor plug wire connector.
Cam
Lock
Lever
2 screws
hold motor
to tray
Motor
Harness
