Rev. 2013.08.19
26
Beverage unit temperature and refrigeration:
Q. What type of environment is the equipment designed for?
A. The Office Deli is specifically designed for indoor use only. Optimal location temperature is
75° F, with 40% RH. Avoid placing unit in direct sunlight.
Q. How do I clean my condenser?
A. Remove the front bottom panel of the refrigeration unit. Brush the dirt and dust from the
condenser fins. You can also blow canned air (available at office supply/computer stores) on
the condenser or vacuum clean it. Do not damage the fins of the condenser while cleaning.
Reassemble the front bottom panel after cleaning.
Q. How do I set my temperatures, and what is the factory recommended low and high
settings?
A. The temperature setting is factory set to industry standard 37º
F for the lower limit, and 42º
F
for the upper limit.
Refer to Page 20 of this manual for instructions on how to alter
temperature settings.
Q. How do I check the temperature on my unit (version 25 or higher)?
A. Press the 10 key to display the current temperature for 20 seconds on the LCD screen.
Q. My beverage selections are not cold enough. How do I get them colder?
1. Check temperature setting by going into tS function, and refer to the steps in this manual on
page 20.
2. Clean condenser coil (see Refrigeration section of this manual). The coil should be clean and
lint free, if dirt or lint build-up is on coil, this will restrict air flow and cause the compressor
temperature to rise above operating temperatures and compromise cooling.
3. Insure condenser fan and evaporator fans are running.
4. Check refrigeration harness and insure proper connection.
Note: this should be done with
power cord unplugged from wall outlet for personal safety.
5. Insure you beverage vendor is placed in a location that it is designed for, which is indoors
only. Outside or non climate controlled environments will compromise cooling.
If further assistance is needed, please contact Seaga Customer Care or a local refrigeration
technician.
Q. My beverages are not cooling at all.
1. Insure through the tS function that the refrigeration deck is turned on. Refer to the steps in
this manual on Page 20.
2. Insure the unit has power – test wall outlet where the unit is plugged in.
3. Check that refrigeration connections are properly connected.
Q. Why does my display switch from “ErrE” to “00.00”? Why are my beverages warm?
1. This is caused by the temperature sensor not communicating.
2. Check to make sure the refrigeration harness is correctly connected to AUX connection on
the VMC.
3. Insure temperature sensor harness is properly connected on refrigeration deck.
4. Once proper connection is made, error will disappear from display. Go into errors and clear
hard error recorded.
Product vending:
Q. Why won’t my snack/entrée selection vend?
1. Check to insure proper connection is made to vend motor.
2. Go into tE, and choose selection, this will home the motor if it is out of home.
3. Inspect harness for visual breaks and replace harness if broken wires are found.
4. If above steps fail, switch motor with known working motor, perform a tE1 test to recapture
motor, then perform an individual motor test to insure that the motor is working properly.
