Rev. 2013.08.19
5
Figure 3 – Making Beverage Connections
4. Electrical Connection between Entrée Unit and Snack/Beverage Unit:
Remove the third tray from the Entrée unit, by flipping up the tray lever (found on the right
side of the tray), disconnecting the tray connector harness, and removing the tray from the
unit. A hole in the rear of the Entrée unit will be exposed. Locate the entrée main harness
and insert it through the hole. Replace the third tray. Move to the rear of the machine and
insert the entrée main harness into the back of the Snack Unit. The harness will be
deposited into the Snack cabinet. Connect the harness to Connector #4. See Figure 3 for the
location of Connector #4.
After finishing the connections, plug the two main power cords to 115V, 15 A outlets. The
outlets should not be controlled by a light switch. Once power is established, the LED display
will first read Software Version and then change to “00.00”. The refrigeration system will also
start running (fans followed by compressor after short delay).
Refrigeration harness plugs into AUX
connection.
Install ground wire ring terminal on
the mounting stud. Remove nut with
adjustable wrench; replace to secure
ground wire.
Beverage main harness attaches to
Connector #5.
Entrée main harness attaches to
Connector #4.
