Rev. 2013.08.19
4
Open all Unit doors and remove the packing materials. Keys can be found in the white envelope
placed in the vend area of the Snack Unit. Remove the tape on the tray levers of the Snack and
Entrée units. Also remove the protective paper from under each helix coil as well as ties securing the
ends of the helix coils during shipping. Remove all protective plastic from the window lenses.
Remember: at least two people are necessary to move any of the components of the Office Deli.
Follow proper safety standard for lifting and working with electronic/refrigerated equipment.
INSTALLATION AT A LOCATION
Once the machines have been unpacked and placed in their permanent location, installation involves
both electrical connection and mechanical attachment. Tools required: Adjustable wrench and Philips
screwdriver. For optimal installation, follow the order of connections as outlined below:
1. Mechanical Connection between Snack and Beverage Units:
The Snack and Beverage units must be screwed together for safety purposes. Two screws
are provided in the white envelope found in the vend area of the Snack unit. Square the
fronts and sides of the Snack and Beverage units. Open the Snack unit door and locate the
two holes at the bottom of the unit. Insert both screws and tighten.
2. Mechanical Connection between Entrée Unit and Snack/Beverage Unit:
Two bolts and washers are provided in the white envelope found in the vend area of the
Snack unit. Open the Entrée unit door and locate the two holes (upper and lower) on the
interior of the right side of the unit. Line up the holes with the corresponding holes in the
Snack/Beverage unit. Insert the bolts and washers and tighten with an adjustable wrench.
3. Electrical Connection between Snack and Beverage Units:
Remove the Styrofoam insert from the opening in the upper right corner of the beverage unit
and save this for reinsertion. Open the Beverage unit door and locate the beverage main
harness and refrigeration harnesses. See Figure 1. Insert harnesses through the opening up
into the Snack cabinet, see Figure 2. Reinsert the Styrofoam piece for maximum insulation of
the refrigeration unit. (You may have to remove a small piece out of the Styrofoam to
accommodate the harnesses.)
Figure 1 – Beverage and Refrigeration Harnesses
Figure 2 – Inserting Beverage and
Refrigeration Harnesses
Connect the beverage main harness to Connector #5 and connect the refrigeration harnesses to
the “Aux” connection on the VMC. Use an adjustable wrench to loosen the ground mounting nut
and install the ground. Secure the nut back on the ground mounting, taking care not to over
tighten. See Figure 3.
Beverage and
Refrigeration
Harnesses
Beverage
and
Refrigeration
Harnesses
inserted up
through
Snack Unit
