Step 10
To completely remove and replace the thruster;
from inside the hull of the HyDrone, remove
the compression-fitting nut with
3
/
4
end wrench.
Then unplug the white, blue, and green wires
one at a time
from the HyDrone. From the
outside of the HyDrone, use a small allen key
or punch to press the black gasket out of the
compression fitting. The thruster wire will now
pull through the HyDrone hull. Install new
thruster by putting new wire through hull then
slide grey gasket followed by the nut, down the
wire from inside the hull. Plug wires back into
wiring harness and tighten compression fitting.
Step 11
Reverse these steps to reassemble thruster. Apply loctite to the bolts.
Page
49
Seafloor Systems, Inc. | [email protected] | +1(530) 677-1019
