Step 7
Remove the propeller from motor assembly by putting pressure on the motor shaft while
pushing the propeller off of the the motor assembly. Be careful not to put too much
pressure on the propeller fins. No further disassembly is required.
Make sure to clean inside of the nozzle
and tail cone
with a non-abrasive brush
.
Step 8
Step 9
Most importantly clean the area between
the motor assembly and the thruster base
as well as the gap, as long grass, fishing
line, anything thin and long will end up in
there. A paperclip or small Allen key
works for cleaning it out. Alternatively,
you can remove the set screw and pull
the two pieces apart for better access.
Page
4
8
Seafloor Systems, Inc. | [email protected] | +1(530) 677-1019
