Sea Ray 44 Sedan Bridge, Руководство пользователя

Страница: 57 / 218

2.25
S
ECTION
2 • G
ENERAL
B
OAT
A
RRANGEMENT
44 Sedan Bridge ( 455 Sedan Bridge )
N
AVIGATION
L
IGHTS
(F
IG
. 2.25.1)
GREEN LIGHT
(VISIBLE 2
NAUTICAL MILES)
RED LIGHT
(VISIBLE 2
NAUTICAL MILES)
MAST LIGHT,
WHITE LIGHT
(VISIBLE 3
NAUTICAL MILES)
ALL-ROUND LIGHT,
WHITE LIGHT
(VISIBLE 3
NAUTICAL MILES)
STERN LIGHT,
WHITE LIGHT
(VISIBLE 2
NAUTICAL MILES)
11. N
AVIGATION AND
A
NCHOR
L
IGHTS
Navigation lights MUST be on while underway from
sunset to sunrise or in conditions of reduced
visibility. “Underway” means the boat is not docked
or at anchor. Trolling or drifting with engine off is
considered “underway” and navigation lights must
be used.
If you are anchored in open water, i.e. where other
boats can approach yours, you must display your
anchor light: a white light that can be seen from all
possible directions, i.e. 360 degrees.
Read the “Federal Requirements and Safety Tips
for Recreational Boats” provided in your kit.
T
O
O
PERATE
T
HE
R
UNNING
L
IGHTS
:
Push RUNNING switch on control station switch
panel to the ON position.
T
O
O
PERATE
T
HE
A
NCHOR
L
IGHTS
:
Push ANCHOR switch on control station switch
panel to the ON position.
A. C
ONSOLE
D
IMMER
There is a DIMMER control switch located on the
control station switch panel which controls the
intensity of the gauge and switch panel lights. The
gauge and switch panel lights are energized when
the navigation running lights are turned on. With
Smart Craft installed, gauge lighting will be
controlled by the system view display.
If you opt to install additional equipment on the hard
top, it then becomes your responsibility to reevaluate
your lighting situation to make certain the navigation
lights on your boat meet government navigational
lighting requirements. You will most likely have to
raise the mast light. Consider the weight of the
equipment you install; be certain it is not to heavy
for your sport spoiler or optional hard top.
The SRN power supply is powered through the 12
volt electronics fuse block under the helm. If the
SRN fails to turn on check the power switch on the
SRN power supply and the fuse on the fuse block
or the external circuit breaker on the power supply.
REFER TO OWNER’S MANUAL PACKET FOR
INSTRUCTIONS AND WARRANTY INFORMATION.
NEED NEW DRAWING