8.7
S
ECTION
8 • R
EQUIRED
I
NSPECTION
, S
ERVICE
AND
M
AINTENANCE
44 Sedan Bridge (
455 sedan bridge
)
5. F
ITTING
O
UT
A
FTER
S
TORAGE
A. F
UEL
S
YSTEM
Check the entire fuel system for loose connections,
worn hoses, leaks, etc. and repair. This is a primary
safety precaution.
Check fuel lines for damage and make sure that
they do not come in contact with any moving parts.
B. B
ATTERY
(
IES
)
Before installing the batteries, clean the terminal
posts with a wire brush or steel wool and then attach
the cables. After the cable clamps are tightened,
smear the post and clamps with vaseline or grease
to exclude air and acid. Do not apply grease before
attaching and tightening the terminal clamps.
Examine all wiring.
C. M
ISCELLANEOUS
•
Check all thru-hull fittings for unobstructed
water passage. Be alert for any deteriorated
hoses and/or fittings below the water line which
might fail in service and admit water.
•
Test the navigation lights.
•
Check all wiring for loose connections.
•
Check all switches and equipment for proper
operation.
•
Check bilge blowers for proper operation.
Turn ON blowers and place hand over hull
blower vent to make sure air is coming from
vent.
•
Anchor lines and gear should be inspected
and replaced if necessary.
•
Make sure the hull drain plug is in place and
tight.
•
Clean bilge thoroughly if it was not done at
lay-up.
•
Check all engine fluid levels.
•
Check fuel lines for damage and/or leaks. Make
sure that they do not come into contact with
moving parts.
•
Diesel fuel should also get a petroleum distillate
additive, such as “Stabil
®
” or Racor
®
RX100”.
This will absorb water in the fuel and prevent
freezing problems.
•
Run engine(s) for ten minutes to ensure that all
diesel fuel in injectors and fuel lines is treated.
DETAILED WINTERIZING, OPERATING INSTRUCTIONS
AND WARRANTY INFORMATION ARE PROVIDED BY
THE EQUIPMENT MANUFACTURER AND CAN BE
FOUND IN THE OWNER’S PACKET.
6. S
EACOCK
L
UBRICATION
•
With boat out of water, remove the hose from
top of the seacock.
•
Put seacock handle in closed position.
•
Add a few drops of lubricating oil inside.
•
Work handle back and forth a few times. Add
oil as needed.
•
Replace hose and tighten clamp.
•
Add a few drops of oil to the handle pivot point.
S
EACOCK
(F
IG
. 8.7.1)
OPEN
HOSE
HOSE CLAMPS
CLOSED
SEACOCK
HANDLE
SEACOCK BODY
PIVOT POINT
Содержание 44 Sedan Bridge
