Sea Ray 44 Sedan Bridge, Руководство пользователя

Страница: 121 / 218

6.19
S
ECTION
6 • E
LECTRICAL
S
YSTEM
44 Sedan Bridge ( 455 Sedan Bridge )
15. H
ALOGEN
L
IGHTING
Your 44 DB uses 12 volt
Halogen lights as the primary
lighting system. The system is
powered by the lighting
breakers on the DC distribution
panel located in the salon and
activated by lighting switches
throughout the boat (See
Section 2 -
General Boat
arrangement, Figures 2.25.1
thru 2.28.1).
A. C
HANGING A
B
LOWN
B
ULB
Use appropriate protection, such as a clean cloth
or gloves when handling or disposing of all Halogen-
cycle bulbs. Wear eye protection. Turn power off
when installing or before removing lamp. Allow lamp
to cool before removal.
Remove grease or fingerprints from new Halogen
bulbs with a grease-free solvent before use.
Grab light fixture housing and
pull gently from ceiling or wall.
Take care when pulling the
housing as it is spring loaded
in the socket and the clips will
snap quickly downward when
released from the ceiling or
wall.
Grab the fixture containing the
bulb and twist counter
clockwise.
Pull the fixture out of the
housing and replace the bulb
with a bulb of equal wattage.
NOTE: The glass face plate
in the housing is very fragile.
Be careful that it remains in
place and does not fall out, as
it will break easily.
To replace the housing,
reverse the previous
directions. Grab the clips and
hold them upwards until the
housing is placed into its
receptacle in the wall or
ceiling. Push gently to seat the
light housing securely.
H
ALOGEN
B
ULB
(F
IG
. 6.19.1)
The filament bulbs used in all halogen-cycle lamps
generate intense heat. To avoid the possibility of
fire, do not use lamp at close range to materials
that are combustible or affected by heat or drying.
Halogen-cycle bulbs are pressurized and could
shatter if scratched or damaged. Glass halogen-
cycle bulbs should be protected against contact
with liquids when operating.
! CAUTION
• Absorption Charge - this stage immediately
follows the bulk charge mode. It maintains the
battery voltage at the bulk charge voltage level,
but gradually decreases the current as the
battery accepts the charge until it reaches a
predetermined current level.
• Float Charge - this stage is designed to hold
the battery at a safe, low voltage (typically 26.5V)
providing up to the chargers full rated amperage
to accommodate DC load requirements. The
charge will remain in this mode until the AC
power is cycled off and then on again.
REFER TO OWNER’S MANUAL PACKET FOR
INSTRUCTIONS AND WARRANTY INFORMATION.