Sea Ray 44 Sedan Bridge, Руководство пользователя

Страница: 80 / 218

44 Sedan Bridge ( 455 Sedan Bridge )
3.18
S
ECTION
3 • U
SING
Y
OUR
B
OAT
• A polypropylene line is a good choice because
it is light, strong and floats.
• If the anchor snags, pull vertically on the tripline
to lift the anchor by the crown.
G. A F
INAL
W
ORD
An anchored boat is affected by wind and sea
conditions. Because there is no headway, there is
no control. Be alert! If leaving the boat, be sure the
anchor will hold under all circumstances.
We suggest you read this section on anchoring
again and fully understand rode and scope and their
affect on anchor performance.
18. W
INDLASS
The windlass is wired to the 12 volt system through
the WINDLASS breaker in the Main Disconnect
Enclosure.
Keep hands, feet, hair and loose clothing clear of
moving parts. Entanglement may cause severe bodily
injury (i.e. lose of fingers or toes).
! WARNING
It is important that the windlass clutch is tight for
proper operation and safety. Periodically check the
clutch and tighten if necessary.
To Tighten Clutch:
With the anchor in the stowed position, tighten the
windlass clutch by inserting the emergency handle
into the clutch nut (see Fig. 3.16.3) and turn clockwise.
NOTICE
W
INDLASS WITH
S
AFETY
L
ANYARD
(F
IG
. 3.18.1)
C
B
A
WINDLASS
SAFETY LANYARD
ANCHOR
The windlass facilitates the anchoring of your yacht
by automatically raising and lowering the anchor. To
operate the windlass the WINDLASS MAIN switch
on the control station switch panel must be ON.
A. T
O
O
PERATE FROM THE
H
ELM
:
• Make sure that the safety lanyard and/or chain
stop are removed from the anchor chain.
• Turn the WINDLASS MAIN rocker switch ON.
• Push the top of the CONTROL rocker switch
(located beside the WINDLASS MAIN on the
control station switch panel) to raise the anchor.
To lower the anchor, push the bottom of the
rocker switch.
B. T
O
O
PERATE FROM THE
B
OW
:
• Make sure that the safety lanyard and/or chain
stop are removed from the anchor chain.
C
B
A
W
INDLASS
C
ONTROL
S
TATION
S
WITCH
(F
IG
. 3.18.3)
W
INDLASS WITH
A
LL
C
HAIN
R
ODE
(O
PTIONAL
)
(F
IG
. 3.18.2)
B
A WINDLASS
CHAIN STOP
B
A
PORT IGN
STOP START/RUN
EMERG
START
BILGE
BLOWERS
ENGINE
SYNC HORN
BILGE PUMPS
FWD AFT
THRUSTER
MAIN 24V
PLATFORM
MAIN
WINDLASS
MAIN CONTROL ACCY
RUNNING
ANCHOR DIMMER
SPOTLIGHT ACCY
STBD IGN
START/RUN STOP
LIGHTS
ACCY
WIPERS
ON/OFF/INT LOW/MED/HI
WINDSHIELD
WASHER