42
7. MAINTENANCE & OPERATION
OTHER INFORMATION
The manufacturer shall not be held liable when the use of the device does not comply with these
requirements.
Claims in respect of any faults caused by inadequate use (e.g. over-firing, not filling up the water jacket,
etc.) shall not be accepted.
File a claim immediately when an alleged fault appears. A delay in filing your claim and continued
use of the device may make the fault worse and damage the insert, and therefore your claim may be
rejected.
The wear and tear of the movable parts (grill, side inserts, back insert, deflector, and seal) shall not
entail any liability of the seller towards the buyer. Full operational capacity of the device depends on
the manner and intensity of use and maintenance. It means that intensive use may reduce the life of
all movable parts below the seller’s liability period of 24 months.
The life of new movable parts will also depend on the manner and intensity of use and maintenance.
The insert is coated with a heat-resistant, and not anti-corrosion paint. Therefore, you should not
install the insert in a place exposed to humidity. Moreover, make sure that only dry fuel is used to
protect the insert against corrosion.
The ceramic glass supplied with your insert can withstand up to 750°C. Any breakages cannot be
caused by overheating, since such a high temperature inside the furnace will never be reached.
