1995-99 Pontiac Sunf re/Convertible
Read pages 3-6
RADIO REMOVAL:
for kit assembly.
1. Open glovebox then remove two screws along the right side
of the radio/heater trim bezel.
"B1" BRACKET USE
2. Carefully pull out on the right side of the radio/heater trim bezel and two
HOLE #1
alignment pins will release on the
"B1" SOPORTE
USA ABERTURA NO. 1
LEFT SIDE
RIGHT SIDE
driver’s
steering
LADO IZQUIERDA
LADO DERECHO
column
panel.
"C2" BRACKET
3. Remove radio/
USE HOLE #5
heater trim bezel.
"C2" SOPORTE USA
ABERTURA NO. 5
4. Extract two screws
holding radio, unplug
and
remove.
FRONT OF KIT
FRENTE DE
TRIM BRACKET
CORTA EL SOPORTE
ESTUCHE
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS & DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
1982-91 Pontiac 6000
Read pages 3-6
RADIO REMOVAL:
for kit assembly.
1. Loosen the screw securing the radio trim panel
to the left side of the glove box.
2. Carefully pull the panel outward to relieve the clips retaining
the left side of the panel. Remove the trim panel.
3. Remove the four screws retaining the radio, and pull the radio out of the cavity.
4. Disconnect the antenna, speaker leads and all the electrical connections, then remove the radio.
LEFT SIDE
"A1" BRACKET USE HOLE #2
LADO IZQUIERDA
RIGHT SIDE
"B1" BRACKET USE HOLE #2
LADO DERECHO
"B1" SOPORTE USA ABERTURA
NO. 2
"A1" SOPORTE USA ABERTURA NO. 2
TRIM BRACKET
CORTA EL
SOPORTE
FRONT OF KIT
FRENTE DE
ESTUCHE
"C2" BRACKET USE HOLE #1
"D2" BRACKET USE HOLE #1
"C2" SOPORTE USA ABERTURA NO. 1
"D2" SOPORTE USA ABERTURA NO. 1
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS & DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
1991-94 Saturn SC, SL, SL1, SL2
Read pages 3-6
RADIO REMOVAL:
for kit assembly.
1. Using a panel removal
tool/screwdriver,
carefully
"C1" BRACKET
pry outward on the dash
USE HOLE #2
"C1" SOPORTE USA
ABERTURA NO. 2
bezel to release the clips
and remove the bezel.
2. Extract the two screws securing
"B1" BRACKET
USE HOLE #2
the radio to the dash. Pull the
"B1" SOPORTE USA
TOP
unit out of the dash, unplug
ABERTURA NO. 2
TOPE
the connectors and
remove the radio.
FRONT OF KIT
FRENTE DE ESTUCHE
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS & DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
28