Schwinn Fitness Force, Руководство по сборке

Страница: 7 / 20

Step 1: Attach Lower Lat Tower to the Base Assembly
Locate the following items:
• I tem #1 - Base Assembly
• I tem #2 - Lower Lat Tower
• I tem #D - (2) 3/8" X 3/4" Button Head Screws
• I tem #G - (2) 3/8" X 4" Button Head Screws
• I tem #L - (6) 3/8" Washers
• I
tem #M
- (2) 3/8" Nylock Nuts
Place the Base Assembly (Item #1) onto the floor. Line up
the base of the Lower Lat Tower (Item #2) with the tube on
the rear of the Base Assembly as shown in
Figure 1
.
Place (2) 3/8" Washers (Item #L) over the ends of (2) 3/8"
X 4" Button Head Screws (Item #G) - one washer per screw.
Insert the screws through the holes in the back of the Base
and Lower Lat Tower, as shown in Figure 1 . Place (2) 3/8"
Washers and (2) 3/8" Nylock Nuts (Item #M) over the end
of each screw - one each per screw - and secure.
Place (2) 3/8" Washers (Item #L) over the ends of (2) 3/8"
X 3/4" Button Head Screws (Item #D) and insert those
screws through the Lower Lat Tower and thread into the Base
Assembly as shown in Figure 1 .
Tighten all hardware at this time.
Step 2: Attach Rail to the Leg Attachment
Locate the following items:
• I tem #3 - Rail
• I tem #4 - Leg Attachment
• I tem #E - (2) 3/8" X 2 1/2" Button Head Screws
• I tem #L - (3) 3/8" Washers
• I tem #M - (1) 3/8" Nylock Nut
Lay the Rail (Item #3) on its side, lining up the holes on
the Rail support bar with the holes on the Leg Attachment
(Item #4), as shown in
Figure 2
. Lift the Pivot Tube out of the
way for this step.
Place (2) 3/8" Washers (Item #L) over the ends of (2) 3/8"
X 2 1/2" Button Head Screws (Item #E) - one washer per
screw. The lower screw will slide through the Rail Support
Bar, and the upper Button Head Screw screws directly into
the Rail - attach the lower Button Head Screw first.
Place (1) 3/8" Washer and (1) 3/8" Nylock Nut (Item #M)
over the end of the lower Button Head Screw to secure it, as
shown in Figure 2 , and tighten.
Assembly Guide
5
D
1
2
Figure 1
M
G
L
M
4
3
Figure 2
L
E
L
Rail
Support
Bar