Assembly Guide
6
Step 3: Attach the Rail Assembly to the Lat Tower
Locate the following items:
• From
Step 1
- Lower Lat Tower and Base Frame Assembly
• From
Step 2
- Rail Assembly
• I
tem #5
- Rail Knob
• I
tem #H
- (1) 3/8" X 4 1/2" Button Head Screws
• I
tem #L
- (2) 3/8" Washers
• I
tem #M
- (1) 3/8" Nylock Nuts
Remove the twist ties from the pivot bushings prior to
commencing this step.
Line up the Lower Lat Tower (Item #2) with the Rail (Item
#3) as shown in
Figure 3
. Pull out the locking pin on the Rail
before you slide the Rail into the pivot bracket. Release the
locking pin to lock into place.
Then loosely install the Rail Knob (Item #5) into the pivot
bracket on the Lower Lat Tower as shown in
Figure 3
.
Place (1) 3/8" Washer (Item #L) over the end of (1) 3/8" X
4 1/2" Button Head Screw (Item #H) and slide the screw
through the Lat Tower and Rail. Secure by placing (1) 3/8"
Washer and (1) 3/8" Nylock Nut over the end of the screw.
Tighten all hardware from this step.
Step 4: Attach Chest Bar w/ Pulleys to Main Assembly
Locate the following items:
• From
Step 3
- Main Assembly (Base Frame Assembly with
Lower Lat Tower Assembly)
• I
tem #6
- Chest Bar with Pulleys and Rod Cables
• I
tem #F
- (2) 3/8" X 2 3/4" Button Head Screws
• I
tem #L
- (4) 3/8" Washers
• I
tem #M
- (2) 3/8" Nylock Nuts
The Chest Bar with Pulleys is the bar with the Rod Hook
wrapped in the bag with the Pulley and Cable.
Line up the holes in the Chest Bar with Pulleys and Rod
Cables (Item #6) with the holes in the Lower Lat Tower
(Item #2), as shown in
Figure 4
.
Place (2) 3/8" Washers (Item #L) over the ends of (2) 3/8" X
2 3/4" Button Head Screws (Item #F) - one washer per screw.
Slide the screws through the holes in the Lower Lat Tower
and Chest Bar with Pulleys and Rod Cables.
Place (2) 3/8" Washers and (2) 3/8" Nylock Nuts (Item #M)
over the ends of the screws (one each per screw), as shown in
Figure 4
and tighten.
Figure 3
H
3
2
1
5
M
L
Figure 4
6
L
F
M
Locking
Pin
Locking
Pin
Rod
Hook
Содержание Fitness Force
Страница 1: ...Assembly Instructions ...
