Step 7: Attach Resistance Rods to the Rod Bracket
Locate the following items:
•
Item #9
- Resistance Rod Pack
•
Item #10
- Rod Bottom Plate
•
Item #B
- (3) #10 X 1" Self Threading Screws
•
Item #J
- (3) 1/4" Washers
There are four 5/16
"
X 3/4
"
Button Head Screws (Item
#C) and four 5/16
"
Washers (Item #K) attached to the
Rod Bottom Plate (see the
Figure 7 inset
). Remove these
Screws and Washers, and set aside until the end of
Step 9
.
Lay the Resistance Rod Pack (Item #9) on the floor and
slide into the Rod Bottom Plate (Item #10) until the Rods
are completely supported by the Plate.
Secure the Resistance Rod Pack to the Rod Pack Bottom
Plate using (3) 1/4" Washers (Item #J) over (3) #10 X 1"
Self Threading Screws (Item #B) - one over each screw -
by threading the screws through the center slot in the Rod
Bottom Plate, as shown in
Figure 7
.
Tighten all hardware from this step securely.
Step 8: Attach Rod Pack Frame to Lower Lat Tower
Locate the following items:
•
Item #11
- Rod Pack Frame
• From
Step 6
- Main Assembly
•
Item #G
- (2) 3/8" X 4" Button Head Screws
•
Item #L
- (4) 3/8" Washers
•
Item #M
- (2) 3/8" Nylock Nuts
Line up the Rod Pack Frame (Item #11) with the lower
holes in the Lower Lat Tower (Item #1) - see
Figure 8
.
Place (2) 3/8" Washers (Item #L) over the ends of
(2) 3/8" X 4" Button Head Screws (Item #G) - one
washer per screw. Slide the screws through the holes in
the Rod Pack Frame and Lower Lat Tower, and secure,
using (2) 3/8" Washers over the ends of (2) 3/8" Nylock
Nuts (Item #M).
Do not tighten at this time.
Assembly Guide
8
Figure 7
9
10
J
B
G
Figure 8
M
11
1
L
G
Содержание Fitness Force
Страница 1: ...Assembly Instructions ...
