Schulte FLX-1510, Руководство оператора

Страница: 70 / 150

OPERATION
FLX-1510 06/18 Operation Section 4-10
© 2018 Alamo Group Inc.
OPERA
T
ION
Hydraulic Cylinder Priming
Hydraulic Cylinders must be filled with hydraulic oil before removing the wing transport pins to lower the mower
wings and deck. Hydraulic cylinders and lines are filled by holding the valve control levers in the raised position
until the cylinders fully retract (wing cylinders) and extend (center cylinder). Place control levers in the float
position and repeat process several more times to purge all air from the system. Ensure wings are entirely
supported by the cylinders before removing the transport pins. NEVER drive out pins and NEVER remove
transport pins that have tension on them.
6.1 Setting Deck Height
The cut height for the center section is set by
extending or shortening the depth collar located on
the center lift cylinder. Cutting height for the wing
cylinders will be automatically controlled by the
hydraulic phasing system. Depth stops are also
provided on the wing cylinders as back up for fine
adjustments.
IMPORTANT: If depth control stops are not set at
the same height as the center cylinder, internal
damage may occur to the phasing cylinders.
The cutter should always be operated in the highest
position that will produce the desired cutting results.
Operating at increased heights will minimize the
chances of blades contacting the ground and
discharging debris.
6. SETTING THE MOWER
Properly setting the cutting height is essential for efficient and safe operation. A properly set mower will make
a more uniform cut, distribute clippings more evenly, require minimal tractor work, and follow the contour of
uneven terrain.
NOTE: Avoid very low cutting heights, striking the ground with the blades gives the most
damaging shock loads and will cause damage to the mower and drive. Blades contacting the ground may
cause objects to be thrown out from under the mower deck. Always avoid operating the mower at a height
which causes the blades to contact the ground.
OPS-U- 0010
Never work under the Implement, the framework, or any lifted
component unless the Implement is securely supported or blocked up
to prevent sudden or inadvertent falling which could cause serious
injury or even death.
(SG-14)