Schuchmann till, Инструкция по эксплуатации, Страница: 25 / 48

25
4.5 Adapter for leg supports (abductable)
Using the hexagon socket screws (
A
) on the
rear side of
till.
, the level can be adjusted
from 0-5 cm.
Additionally, using the the hexagon socket
screw (
B ) the angle on each leg can be
individually steplessly adjusted between 0°
and 30°.
After each adjustment, tighten again all screw
connections and clamping levers!
4.6 Leg supports (flex)
The leg supports (flex) can be adjusted in
length and angle.
For the length adjustment of the leg there
are two setting screws that are essential.
If you loosen the upper hexagon socket
screw (
C
), you can lengthen or shorten the
thigh dimensions by pulling or pushing.
When you loosen the lower screw (
D
)
you can bring the lower leg dimensions to
the desired length.
To adjust the angle, put the knee pelotte
upright, align it according to the patella and
press it down until achieving a knee flexion that is adequate to and still
tolerable by the patient. Now hold the leg support at the foot and loosen
both angle adjustment tubes via the clamping levers (
E + F ). Lift the flexible
leg support on the knee pelotte pad adapter until contact is established
between the back of the knee and the upper edge of the lower leg pad.
Subsequently, fix the angle adjustment tubes again using the clamping
levers (
E + F ) and adjust again the knee pelotte pad. When using the
abductable adapter of the leg supports, you can now bring the abduction
angle into the desired dimension (see
Point 4.5 ).
After each adjustment, tighten again all screw connections and clamping levers!
B
4. Accessories.
A A
E
F
C
D