Schuchmann carrot 3, Инструкция по эксплуатации

Страница: 43 / 60

43
5. Accessories.
5.17.8 Foot support fixture
To attach a
carrot 3.
foot support to
the ISO-TURN, you need the foot
support fixtures (
A ) as an accessory.
Please note that, depending on the
design of the car seat, the cover fab-
ric may be damaged by friction due
to these fixtures. To avoid this, a foam
spacer (
B ) is available which you can
place under the ISO-TURN. However,
we cannot guarantee that the up-
holstery of your car will not be dam-
aged. You must check yourself on site
that no chafe marks can damage the
pads.
To mount the foot support fixture, please place the fixture against the
turntable (
C ) from below and align it so that the holes of the fixture and
the plate are on top of each other. Now screw in the four screws supplied
and tighten them well. To fix the foot support (to prevent it from sliding out
to the front), a screw is also included in each case, which is turned into the
hole provided and tightened well after the foot support has been posi-
tioned correctly. To remove the foot support, loosen the fixing screws again
and pull the foot support straight out to the front.
5.17.9 Included in the ISO-TURN scope of supply
B
A
C
• Extended screw connection for
connecting the seat and back with
the ISO-TURN
• Back angle adjustment of the
backrest if fixed screw connection
is not desired
• Isofix holders for retrofitting to avoid
transport damage
• Fastening of both Isofix holders to
the base plate
• Footwell support for attachment
to base plate (retrofitting to avoid
transport damage)
2 cylinder Allen screws 6x35 mm
2 locking nuts SM 6
2 clamping levers 6x20 mm
2 washers 6x18 mm
2 units
8 countersunk head screws 6x20 mm
2 part incl.
4 cylinder Allen screws 6x20 mm
4 washers 6x18 mm