Schmalz 10.02.02.05235, Руководство по эксплуатации

Страница: 34 / 72

General Description of Functions
34 / 72 EN-US · 30.30.01.01484 · 00 · 01/21
7.26.1 Condition Monitoring (CM)
Monitoring the valve switching frequency:
When the air saving function is activated and there is a high leakage level in the gripping system, the
ejector switches between the suction and suction-off states very frequently. The number of valve switch-
ing procedures thus increases rapidly within a short time. To protect the ejector and increase its service
life, the ejector switches the air saving function off automatically at a switching frequency of more than 6
times every 3 seconds and activates continuous suction; the ejector then remains in the suction state. In
IO-Link mode, the appropriate condition monitoring warning is also set. In addition, the system status
light switches to yellow.
The basic monitoring for the valve protection function is also active in SIO mode.
Schematic diagram of the valve switching frequency
Vacuum
[mbar]
Time [s] Suction ON
With the [
dC5
=
on
] setting, continuous suction is deactivated, and the ejector continues in control
mode despite a high leakage rate or control frequency greater than 6 times per 3 s.
Monitoring the Control:
If the vacuum limit value H1 is never reached during the suction cycle, the “H1 not reached” condition
monitoring warning is triggered and the system status light switches to yellow.
This warning is available at the end of the current suction phase and remains active until the next suction
cycle.
Measuring and monitoring the evacuation times:
t0 is the time from the beginning of a suction cycle to when the vacuum limit value H2 is reached (in ms).
t1 is the time from when the vacuum limit value H2 is reached to when the vacuum limit value H1 is
reached (in ms).