Pilot²
Doc. No. 610 2221 v07
- 25 -
(*applicable with the ultrasonic extension module)
4.3.
Preparation
After selecting the file system and the desired file, the Endomotor is started up using the foot
switch in the Preparation menu. The selected file appears in the upper line. The speed and
torque values of the file are indicated below.
In addition to the currently selected file, further files are
shown. You can select these by tapping on or swiping
them directly.
Press the
button to call up ‘Setup Motor’ (see 4.5).
Here, you can configure the settings for the motor drive.
Changed values are displayed with a red exclamation
mark.
The apex display is always in operation and thus also
allows manual probing with the help of the file clamp.
Please note that the file clamp must be stored in an
insulated place. Otherwise, incorrect measurements may
occur during the length determination using the contra-
angle.
*By pressing the ultrasonic- icon you can switch to the
ultrasonic-menu
(if the ultrasonic-extension-module is mounted).
You can switch the integrated apex measurement off and on again during preparation by
pressing the green apex icon at the right edge of the screen.
4.4.
MyFile file system
The MyFile system offers 5 sequences for free
configuration. Select one of the ‘MySequence’ sequences
from the menu (sequence 1 has been chosen here).
Sequences that have not yet been filled are displayed in
grey.
Now copy up to 10 instruments from existing file systems
into the sequence in any order.
To copy, press the green plus button at the desired
position and select a file.
You can change the file parameters (speed, torque...) of
the files copied into the MyFile file system as desired.
These changes have no repercussions on the data in the
original file system.
You can delete entries again with the Minus button
