SBS System – SB-1000 Operation
9
Startup and Operation
Power-On Display
Power on display shows only after power is applied, and displays for 2 seconds. Press and hold the
Cancel button to extend the duration of this display until button is released. For support reference, the
installed Firmware rev. is displayed at the right side of this screen, and below that the FPGA code rev.
Multiple Machine Operation
Press and hold the Setup
button to access the screen for selection of single machine or multiple machine
operation.
The first icon selects single machine operation, and the second icon selects multiple machine operation.
When in multiple machine operation, the control saves setup information for up to eight separate machines,
using a machine ID number of 1-8. This is useful where the control will be moved between machines with
different setup requirements. Single machine operation should be used for a dedicated installation.
When Multiple Machine operation is selected, the power up screen for the control is immediately followed
by the machine selection screen. This allows the user to verify that the selected machine ID matches the ID
of the machine the control is operating on. It is recommended that the grinding machines in such a scenario
are labeled with the appropriate machine ID number for reference.
The first screen shown indicates that machine 3 is selected and it is setup for Manual balance mode ( ).
The second screen indicates that machine 4 is selected and it is setup for Automatic balance mode (
). If
no balance mode is setup for a particular ID number, then the ( ) on screen will be empty. This indicates an
available or unused ID.
Use the arrow buttons
to change the machine number selected.
Pressing will accept the current selection and go to the Main screen.
Pressing
will accept the current selection, and show the select balance mode screen, allowing the balance
mode to be changed for the selected machine.
