SATELLINE-3AS
User Guide, Version 2.3
71
9.2 Changing parameters using the LCD-display
SATELLINE-3ASd contains a LCD-display that allows modification of the radio modems
configuration settings without the use of an external terminal device. This is especially convenient
when modifying or re-installing radio modems in the field. The radio modem is switched into
Programming Mode
by pressing the ”SET-UP-button (
¡
). First, the LCD-display will shortly
display the model of the radio modem and the software revision information, after which it will
automatically display the main menu, which is a list of the modifiable configuration settings.
The main menu is used to select the desired submenus, and the modifications are performed
using these submenus. It is possible to jump back at any time to the previous (higher) level in the
menu hierarchy by just pressing the ”CANCEL”-button (or in some cases the ”BACK”-button).
Pressing the
5
or
6
button modifies parameters with numerical values consisting of digits. Use
until the said digit (with the cursor blinking under it) has reached the desired value. In the case
of numerical values the ”NEXT-button is used to move on to the next digit in the numerical value
and then the above described process is used to modify it. The process is repeated until all digits
in the value have been edited. Toggle-type parameters (typically with ON/OFF choices
modifications have to be confirmed by pressing the ”SELECT”- or ”SET”-button.
This is the display in
Data
Transfer Mode
. Serial port
PORT 1 settings are
19200,N,8,1. Frequency is
set to 468,5000 MHz.
Signal strength is displayed
on the upper left-hand
corner and battery level
respectively on the upper
right corner.
öÄÄÄÖÖ äÄÄÄÖÖ
468.5000 MHz
COM1:19200N81
Setup
After pressing the ”SET-UP-
button the display will shortly
show the model of the radio
modem and the revision of
the software.
SATELLINE-3AS
Version 2.06
The display will
automatically then show the
main menu, which is a list of
modifiable parameters.
Pressing the
ý
and
þ
buttons
can move the cursor
upwards and downwards.
When the cursor
>
is placed
beside the desired selection,
entry into sub-menu is done
by pressing the SELECT-
button.
>RF frequency
Radio settings
Addressing
Port 1
Port 2
Handshaking
Additional
Tests
Factory setup
Contrast
EXIT
ýþ
SELECT
