SATEL KNX-BIN24
39
Communication objects: Switch / Value transmitter
No.
Object name
Object function
Data type
Flags
During configuration of the module, the object can be enabled in the “General” tab (that can
be seen after opening the “Function blocks” tab), when the “Switch” function is selected in
the “Function block 1” field. The object value can be changed by a short button press event
or a telegram from the KNX bus. The possibility to change object value by a telegram from
the bus enables the object value to be updated each time when switching is triggered by
another communication object from the same address group. If you do not want the object
value to be changed by telegrams from the bus, disable the “W – Write” option in the object
properties. The data type and value that can be assumed by the object are defined in the
“1: Switch” tab:
1-bit value [0/1] – DPT 1.001 (on / off).
1-byte value [0…255] – DPT 5.* (set value).
1-byte value [0…100%] – DPT 5.001 (set percentage value).
4-bit value [1…100% Darker; Stop; 1…100% Brighter] – DPT 3.007 (set brightness
value).
4-bit value [1…100% Up; Stop; 1…100% Down] – DPT 3.008 (set shutter value).
The object can send telegrams cyclically to the KNX bus with information on the current
value. Entering value “0” in the “Interval of value cyclic sending (short pressing)” field will
disable the cyclic sending.
See “Switch”
11
FB 1: switch
Long pressing
(1-bit) / (1-byte)
/ (percentage)
/ (dimming
control)
/ (shutter
control)
1 bit,
DPT 1.001
1 byte
DPT 5.* 8-bit
unsigned value
4 bit,
DPT 3.007
4 bit,
DPT 3.008
C, R, W, T
The object will be enabled, if you select “Yes” for the “Event on button long pressing” option
in the “1: Switch” tab. The object value can be changed by a long button press event or
a telegram from the KNX bus. The possibility to change object value by a telegram from the
bus enables the object value to be updated each time when switching is triggered by
another communication object from the same address group. If you do not want the object
value to be changed by telegrams from the bus, disable the “W – Write” option in the object
properties. The data type and value that can be assumed by the object can be defined in
Содержание KNX-BIN24
Страница 11: ...SATEL KNX BIN24 9 See also other Configuration examples...
Страница 13: ...SATEL KNX BIN24 11 Description of parameters...
Страница 48: ...46 KNX BIN24 SATEL 4 7 2 Using timer channel...
Страница 50: ...48 KNX BIN24 SATEL...