SATEL GPRS-T6
17
status information when the telephone number, identified owing to the CLIP service, is one
of the numbers programmed in the "GSM telephone, Monitoring stations" tab on
the "Telephone numbers for messaging and test transmissions" list.
If the "Reaction to CLIP only when number is on list of telephones for messaging"
option is not enabled, the test transmissions and SMS messages with information on
device status:
for the numbers in the list, they will be sent by the module immediately,
for the numbers not in the list, they can be sent by the module every 10 minutes at
the most.
Control
SMS messages can be used to control the module inputs and outputs. The SMS message
sent to the module may contain only one control command. The control command may
contain up to 24 characters. The control commands relating to inputs can be defined in the
"Inputs" tab.
Control
SMS control only from list of telephone numbers for messaging
– if this option is
enabled, the functions of enabling, disabling or time-enabling the output, as well as
blocking/unblocking the inputs will only take effect after the SMS message is sent from
a telephone number which is programmed in the "GSM telephone, Monitoring stations"
tab in the "Telephone numbers for messaging and test transmissions".
Confirm controlling with status SMS
– if this option is enabled, starting the functions of
turning on, turning off or turning on for a period the output, as well as
blocking/unblocking the inputs will result in sending by the module of an SMS message
containing information on the module status to the telephone number from which
the control message was sent (see: "Send SMS with module status to CLIP" option).
Output OUT1 ÷ OUT4
Turn on
– enter in this field the SMS message content that will be sent to the module
telephone number in order to activate the output.
Turn off
– enter in this field the SMS message content that will be sent to the module
telephone number in order to deactivate the output.
Turn on for period
– enter in this field the SMS message content that will be sent to
the module telephone number in order to activate the output for a defined period of time.
Output cut-off time
– if the output is to be activated for a period of time, the time must be
defined. After the time runs out, the output will be deactivated. You can program times
up to 18 hours 12 minutes and 14 seconds. If the output cut-off time is not programmed,
activating the output for a period of time will be impossible.
NC
– if the option is enabled, the output will operate as the NC (normally closed) output.
When the option is disabled, the output will operate as the NO (normally open) output.
Trouble status
– if this option is enabled, the OUT4 output indicates a problem with
logging into the GSM network. It will activate about 2 minutes after the problem has
occurred. In its active state, it will be shorted to the common ground. It will remain
shorted to the ground until logging into the GSM network. The problem with logging into
the GSM network can be caused by:
– missing SIM card,
– entering a wrong PIN code,
– missing or damaged antenna,
– unavailable GSM network (out of range),
