Satel ACU-270, Руководство пользователя

Страница: 16 / 27

14 ACU-270 SATEL
ARU
– parameter available for a wireless device, if the ARU-100 repeater is registered in the
controller (the controller is connected to the INTEGRA or INTEGRA Plus control panel). It
allows you to define whether the device is to communicate to the controller directly, or via
the selected ARU-100 repeater (several ARU-100 repeaters can be registered in the
controller). The programming procedure is described in section “Programming in the
INTEGRA / INTEGRA Plus system”
(p. 15).
Always active
– the option is available for the most of wireless detectors. If enabled, the
detector is permanently switched over to the active mode (see “Wireless detectors” p. 17).
The AMD-103 detector and the wireless detectors assigned to 24-h zones are always
in the active mode, therefore the A
LWAYS ACTIVE
option does not have to be enabled
for them.
Configuration
– some of the wireless devices provide additional parameters and options,
which can be configured by radio (shown in square brackets is information on the zone for
which additional parameters can be programmed, if the device takes up more than 1
zone):
AGD-100
– wireless glass-break detector. Sensitivity is to be programmed.
AMD-100
/
AMD-101
– wireless magnetic contact. The active reed switch is to be
selected.
AMD-102
– wireless magnetic contact with input for roller shutter detector. The following is
to be programmed:

active reed switch [first zone];

number of pulses after which alarm will be triggered by the roller shutter input
[second zone];

time during which the specified number of pulses must occur for the roller shutter
input to trigger alarm [second zone].
AOD-200
– wireless outdoor dual technology motion detector. The following is to be
programmed:

sensitivity of PIR sensor;

sensitivity of microwave sensor;

sensitivity of dusk sensor (detection threshold).
APMD-150
– wireless dual technology motion detector. The following is to be
programmed:

sensitivity of PIR sensor;

sensitivity of microwave sensor;

the way of operation in test mode.
APD-100
– wireless passive infrared detector. The following is to be programmed:

sensitivity,

option of immunity to pets up to 15 kg.
ARD-100
– wireless reorientation detector. Sensitivity is to be programmed.
ATD-100
– wireless temperature detector. For both positions occupied by detector, the
temperature threshold parameters can be programmed (thus two different temperature
threshold can be programmed):

threshold type: high (when the temperature rises above the defined temperature
value, alarm will be triggered) or low (when the temperature drops below the defined
temperature value, alarm will be triggered);

temperature;