6 ACU-270
SATEL
The conductors must be run in one cable. Prevent the cables from coming into contact
with sharp edges to avoid damage to the cables.
9. Connect the power cables to the 12V and COM terminals. Use conductors with a cross-
section of 1 – 2.5 mm
2
. The controller may be powered directly from the control panel,
from an expander with power supply, or from a power supply unit with current limitation up
to 3 A.
10. Close the controller enclosure.
11. Power on the alarm system.
12. Start the identification function in the control panel (see the control panel installer
manual). The module will be identified as “ACU-100”.
5. Programming the controller
Programming of the controller is carried out by means of the control panel, using:
the LCD keypad in service mode:
– INTEGRA / INTEGRA Plus – the controller programming functions are available in the
S
ETTINGS
submenu (
S
TRUCTURE
H
ARDWARE
E
XPANDERS
S
ETTINGS
). Upon
entering the submenu, a list of devices will be displayed. Using the
and
keys, find
the controller name and press the key to get access to the list of functions. To
program the controller name, use the N
AMES
submenu (
S
TRUCTURE
H
ARDWARE
E
XPANDERS
N
AMES
).
– VERSA / VERSA Plus / VERSA IP – most of the controller parameters can be
programmed in the 2.
S
ETTINGS
submenu (
2. H
ARDWARE
1. K
PDS
&
EXPS
.
2. S
ETTINGS
). Upon entering the submenu, a list of devices will be displayed. Using
