ANTENNA
BLACK
AC POWER SUPPLY
(Mains/Live)
(Mains/Neutral)
WHITE
BLACK
BLUE
(Light/Live)
(Fan/Neutral)
WHITE
(Fan/LIVE)
BLACK
CR2430 3V
How to Wire and Operate Your BTCR9 Remote Control
Figure 3
Figure 1
Figure 2
ON DIP
Dip Switch
Dimmer Switch
DIMMER
ON/OFF
4. Pairing Process for Receiver & Transmitter:
(Figure 3)
– The receiver and accompanying transmitter are matched
at the factory. If replacing transmitter or receiver, you must
follow the pairing process below before using the unit. The
fanSync receiver can be paired to up to five (5)
transmitters. NOTE: Smart device pairing is unlimited.
– After installing the receiver unit, set desired transmitter
code by pushing dip switches (under battery cover) up or
down to the desired positions. Once code is set, restore
power to your fan and press and hold the fan off button ( )
for approximately 1 to 3 seconds. The light will blink twice
and fan turn on to medium speed to indicate that the
pairing process is complete. Please note that you must
press the fan off button ( ) within 30 senconds after
restoring power. Re-pairing your device is not necessary
after replacing the battery. Each fanSync receiver can pair to
five different transmitters (with different dip switch codes).
If light kit uses CFL bulbs, please slide the “light dimmer
function select switch” to on/off position. If incandescent
light bulbs are installed, please slide the “light dimmer
function select switch” to dimmer position.
NOTE:
Transmitters can pair to multiple receivers, when
performing the pairing process take care not to pair the
transmitter to unintended receivers. It is suggested that
fans more than seven feet apart be on separate power
switches.
CAUTION:
INCORRECT WIRE CONNECTION WOULD
DAMAGE THIS RECEIVER.
1.
Ceiling fan must be set at HIGH speed and light kit (If
any) in the ON position.
2.
Connect wires using connectors as shown in Figure 1.
3.
Once the connection has been made, slide the receiver
into the hanger bracket, taking care not to pinch the wires
The canopy comes up to cover the receiver and hanger
bracket. (Figure 2)
WARNING
To avoid possible electrical shock, be sure electricity is
are not sure if the outlet box is grounded, contact a
licensed electrician for advice, as it must be grounded for
