Entris
®
BCE Operating Instructions
25
System Settings
Parameter
Setting values Explanation
DEC .PLCS
NONE
The result of the “Calculation” application is displayed without decimal places .
1 DEC .PL .*
The result of the “Calculation” application is displayed to 1 decimal place .
2 DEC .PL .
The result of the “Calculation” application is displayed to 2 decimal places .
3 DEC .PL .
The result of the “Calculation” application is displayed to 3 decimal places .
* Factory setting
7.3.16 “APPLIC.”/”DENSITY” Menu
Parameter
Setting values Explanation
DEC .PLCS
NONE
The result of the “Density determination” application is displayed without decimal places .
1 DEC .PL .*
The result of the “Density determination” application is displayed to 1 decimal place .
2 DEC .PL .
The result of the “Density determination” application is displayed to 2 decimal places .
3 DEC .PL .
The result of the “Density determination” application is displayed to 3 decimal places .
* Factory setting
7.3.17 “APPLIC.”/”STATIST.” Menu
Parameter
Setting values Explanation
PRT .COMP .
OFF
Deactivates the component printout .
ON*
Activates the component printout .
TAR .STAT .
OFF*
Deactivates automatic taring after the components are saved .
ON
Activates automatic taring after the components are saved .
* Factory setting
7.3.18 “APPLIC.”/”PEAK.HLD.” Menu
Parameter
Setting values Explanation
APPLY
AT STAB .*
Peak values are applied when there is stability .
W/O STB .
Peak values are applied without stability .
* Factory setting
7.3.19 “APPLIC.”/”CHECK.WG.” Menu
Parameter
Setting values Explanation
INPUT
MANUAL*
The min/max limits are entered manually .
WG .VALUE
The entry of the min/max limits is carried out by applying the weight value .
AUTO .PRT .
OFF*
The automatic printing is switched off .
ON
With automatic printing, all values are exported .
OK ONLY
With automatic printing, only values that are within the control range are exported .
NOT OK
With automatic printing, only values that are outside the control range are exported .
* Factory setting
