8
9
20
The Sapling Company, Inc.
670 Louis Drive
Warminster, PA 18974
USA
P. (+1) 215.322.6063
F. (+1) 215.322.8498
www.sapling-inc.com
Dual-Faced / Flag Mounted Clock Mechanical Installation
9) Removing the end cap from the clock housing will allow to place the pole flush with the back of the
clock housing. Position the pole so its allocated mounting holes are aligned with the clock housing. Once
in position, use the four #8-32x7/16 screws and the internal-tooth washers to mount the clock housing
to the pole using a Philips screwdriver. For a dual-faced clock, repeat the same with the second clock
housing so both back clock cases are mounted to the pole.
8) If the clock is to be mounted to the pole and suspended from the ceiling, then the top end cap is to
be removed. If the clock is to be mounted to the pole and suspended from the wall, one of the side end
caps is to be removed. For doing so, use a screwdriver to remove one of the end caps located on the
back of the digital clock housing based on the orientation of the digital clock that will be attached to the
pole. The end cap and screw that was used to secure it will not be needed again during this installation.
* = end caps
*
*
*
*
*
