3
Zoom/Focus adjustment terminal (ZOOM/FOCUS)
Zoom and focus adjustment operations can be performed remotely by external voltage control.
4
COM terminal (GND)
To record live video on a hard disk, put the hard disk in a dedicated hard disk case (VA-HDC4000) (sold
separately) and then connect the case to the camera.
For details, refer to “Formatting the recording media”.
Connect this jack via an audio cable to the audio input jack of an amplified speaker system or the monitor.
Use this jack to connect an external microphone to listen to the sound while monitoring the live video, or
simultaneously record the video and sound.
This jack supports 3.5-mm diameter monaural microphone plugs, or monaural line-level input plugs (the
left channel only for stereo plugs).
When recording live video onto an SD memory card, insert the card into the slot.
For details, refer to “Formatting the recording media”.
Use this socket to connect the camera to your PC to enable network operation.
For details, refer to the “Basic Connections” section.
Link access indicator (Green):
This indicator lights up approx. 3 seconds after power on, if a connection has been established
between the camera and the network.
After that, it will blink when data are being transmitted via the network.
Speed indicator (Orange)
The camera automatically detects the local network transmission speed (10BASE-T or 100BASE-
TX).
This indicator lights up when 100BASE-TX data transmission is in progress; it goes out when
10BASE-T data transmission is in progress.
Connect this terminal to a monitor, etc. A live video will be displayed on the monitor once the camera is turned on.
For details, refer to the “Basic Connections” section.
Introduction 8/23
