Sanyo SAP-CRV12AEH, Руководство по обслуживанию

Страница: 47 / 108

(2) Disengage the 3 hooks on the upper part. (Fig.11)
In case that the hooks are not pressed from above, remove the front panel and then remove
the grille while pushing the hook through a clearance between the front grille and the heat exchanger.
Disengage the hooks by pressing knobs with a screwdriver.
(3) The front grille can be removed o pull out the upper part forward and lift up the lower part. (Fig.12)
NOTE
9-1-5. Removing the vertical blade
(1) Unfasten the hooks at the upper 2 positions. (Fig.13 and Fig.14)
1. A set of vertical blade has 6 fins as on assy. (It is impossible to replace only one fin.)
2. The set of vertical blades is not marked for difference between right and left.
NOTE
(2) Unfasten the 3 hooks at the shaft mounting part by pressing them with a flat screwdriver. (Fig.15)
Repeat the same procedure to remove the vertical blade on the other side.
(3) Remove the vertical blade. (Fig.16)
NOTE
Left
Center
Right
Hooks
Fig. 11 Fig. 12
Fig. 13 Fig. 14
Fig. 15 Fig. 16
Hook
Hook
Vertical blade
47