1. Specifications
1
1
2
3
4
5
I - 100
SM830080
NOTE
Indoor Unit
AVOID:
●
areas where leakage of flammable gas may be
expected.
●
places where large amounts of oil mist exist.
●
direct sunlight
●
locations where nearby heat sources may affect
performance of the unit.
●
locations where nearby external air may enter the
room directly. This may cause “sweating” on the
air discharge ports, causing them to spray or drip.
●
locations where the remote controller will be
splashed with water or affected by dampness or
humidity.
●
installing the remote controller behind curtains or
furniture.
DO:
●
select an appropriate position from which every
corner of the room can be uniformly cooled.
●
select a location where the ceiling is strong
enough to support the weight of the unit.
●
select a location where tubing and drain pipe
have the shortest run to the outside.
●
allow room for operation and maintenance as
well as unrestricted air flow around the unit.
●
install the unit within the maximum elevation
difference (H) above or below the outdoor unit
and within a total tubing length (L) from the
outdoor unit as detailed in Table 1-1.
●
allow room for mounting the remote controller
about 1 m off the floor, in an area that is not in
direct sunlight nor in the flow of cool air from the
indoor unit.
Air delivery will be degraded if the distance from the
floor to the ceiling is greater than 3 m.
1-11 Installation Instructions
Selecting the Installation Site
Ceiling-Mounted Type
2-Way, 4-Way Semi-Concealed Type
0021_X_I
1m
1m
1m
1m
1m
1-Way Semi-Concealed Type
Wall-Mounted Type
5 cm min.
5 cm min.
1 m min.
Air
intake
Air
discharge
Obstacle
Ceiling
Wall
Wall
0022_AS_I
15 cm min.
Front View
0023_K_I
15 cm
min
15 cm
min
0020_T_I
25 cm min.
Front view
The rear of the indoor unit can be installed flush
against the wall.
30 cm
min.
Air intake
Air
discharge
Side view
NOTE
25 cm min.
Ceiling
Wall
NOTE