SANKI P212-F, Инструкция по эксплуатации

Страница: 29 / 40

27/36
10. “ io ” Mode Setting Function
This Controller can switch the control target of [in2 Input].
The functions that the
“ io ” mode setting can perform:
① Switching of the “ io ” mode
② Initialization of the set data [Reset to the factory setting]
Function Control target
io01 Controls the feeder output in [in2 Input]. [with overflow stop] (factory setting)
io02 Does not control the feeder output in [in2 Input]. [without overflow stop]
io03
[in2 Input] is pattern switching input [Lo fixed].
io04
[in2 Input] is pattern switching input [hi fixed].
99 Initializes the set data [Resets to the factory setting].
1) “ io ” mode switching method
(1) When the power supply to the Controller is OFF, power ON the Controller by pressing both
the Vol ▲ key and the Freq ▼ key together.
(2) The data display area displays “io01” to start the Controller.
※ If the Controller starts in a normal manner, redo the above (1) and (2).
(3) Press the Freq ▲ key to select the “ io ” mode to be used.
The display switches “ io01 ” → “ io02 ” → “ io03 ” → “ io04 ” → “ 99 ” → “ io01 ” in this
order.
When the Freq
▼ key is pressed, the display area switches them in the reverse order.
(4) Press the Set key long for 2 sec to start the controller in a normal manner in the selected “ io ”
mode.
For example, when “io02” is selected, “io02” is displayed when the “ io ” mode is displayed
upon powering ON the controller.
2) Motion in each “ io ” mode
According to the selected “ io ” mode, the functional assignment of the input signals (in1 – 3) are
differing as follows:
Function of input signal
Signal name io01 / io02 io03 / io04
in1
External signal input External signal input
in2
Overflow sensor input Pattern switching input 2
in3 Pattern switching input 1 Pattern switching input 1