SANKI P212-F, Инструкция по эксплуатации

Страница: 22 / 40

20/36
0.0
30.0
30.0
240.0
150.0
30.0
10.0 25.0
150.0 SAVE
152.0 25.0
ON/OFF
key
※ Adjusts the frequency
to the frequency that
raises the parts feeding
speed to the fastest.
At this time, if the
vibration becomes too
intensive, lower the
output%.
Vol ▲ key
Vol ▲▼ keys
④ -A: When the Vibration Sensor KS-3 is not used (0u=0)
※ Performs the following
in the forced operation.
<Meaning of RUN lamp status>
ON: In operation by remote control
OFF: Operation at a stop (when remote
control is OFF)
Quick blinking: In forced operation
Slow blinking: Forced operation at a stop
* Forced operation means
⇒ Forcedly starting/stopping the operation by
pressing the ON/OFF button whether the
operation is remote-controlled or not
Freq ▲▼ keys
▼Ｆｒｅｑキー
※ Switches the output%
setting screen to the
frequency setting screen.
※ Switches the frequency
setting screen to the
output% setting screen.
Vol ▲▼ keys
※ Lowers the output%
until the speed is
lowered to the speed
at which the parts
moves slightly.
Press the Set
key long for 2
sec.
※ Adjusts the output%
to the output% that can
achieve the required
speed.
Vol ▲▼ keys
“SAVE” is an operation to save the frequency
and the output% to the main unit of the
controller.
When the display of
“SAVE” blinks, is means
that the data has been saved.
(When 0u=1 and 2, the vibration quantity is
also saved.)
If the main unit of the Controller is powered
OFF without the SAVE operation, the data will
not be saved.
Therefore, be sure to perform the SAVE
operation when the feeder is in operation.
※ Go to < ⑤ Switching from the adjustment mode to the operation mode>.
Freq ▲▼ keys
Freq ▲▼ keys
Blinking
※ Sets the output%
to approx. 30 － 50%.
※ Adjusts the frequency
to the frequency that can
achieve the best travel of
the parts.
※ Switches the output%
setting screen to the
frequency screen.