S&C 5800 Series, Руководство по устранению неисправностей

Страница: 4 / 34

4
S&C Instruction Sheet 1041-550
Ç
WARNING
These instructions do not replace the need for utility operation standards. Any
conflict between the information in this document and utility practices should be
reviewed by appropriate utility personnel and a decision made as to the correct
procedures to follow.
Serious risk of personal injury or death may result from contact with electric
distribution equipment when electrical isolation and grounding procedures are not
followed. The equipment described in this document must be operated and main-
tained by qualified persons who are thoroughly trained and understand any hazards
that may be involved. This document is written only for such qualified persons and
is not a substitute for adequate training and experience in safety procedures for
accessing high-voltage equipment.
The S&C 5800 Series Automatic Switch Control is connected to switchgear oper-
ating at primary voltage levels. High voltage may be present in the wiring to the
switch control or the switch control itself during certain failures of the switchgear
wiring or grounding system, or due to a failure of the switch itself. For this reason,
access to the switch control should be treated with the same safety precautions that
would be applied when accessing other high-voltage lines and equipment. Follow all
locally-approved safety procedures when working on or around this switch control.
Before attempting to access an existing switch installation, check carefully for
visible or audible signs of electrical or physical malfunction (do this before touching
or operating the switch control or any other part of the installation). These warning
signs include such things as smoke, fire, open fuses, crackling noises, loud buzzing,
etc. If a malfunction is suspected, treat all components of the installation, including
the switch control and associated mounting hardware, as if they were elevated to
primary (high) voltage.
Whenever you are manually reconfiguring the circuit (for example, during repairs),
follow your company’s operating procedures to disable automatic operation of the
S&C 5800 Series Automatic Switch Control. This prevents any unexpected operation.
Applicable Software This instruction sheet was prepared for use with all stand-alone (not IntelliTEAM®
or IntelliTEAM II®) 5800 Series Software available November 2008: DNP Protocol:
SNCD2S0V Rev. 2.42, PADD2S0X Rev. 2.44, USBD2S0X Rev. 2.40, UDSD2S0X Rev.
2.26
PG&E Protocol: SNCP0S0X Rev. 2.21, USBP0S0X Rev. 2.29, UDSP0S0X Rev.
2.32 Intrac Protocol: SNCI0S0X Rev. 2.18, USBI0S0X 2.30.
Software Available December 2010: DNP Protocol: SNCD2S0X Rev. 2.45.
The revision number is on the setup disk label and on the IntelliLINK software TROUBLE-
SHOOTING: Control & Switch Information screen. For questions regarding the applicabil-
ity of information in this instruction sheet to future product releases, please contact S&C.
IntelliLINK Software