Samsung Ubigate iBG3026, Руководство по настройке

Страница: 610 / 718

CHAPTER 33. Routing and Digit Manipulation
568
© SAMSUNG Electronics Co., Ltd.
It does not always need Inbound dial peer. If dial peer configured
against Inbound call leg does not match, use the already defined
default dial peer as inbound dial peer. Dial peer 2 of Ubigate iBG3026 B
in the figure 37.6 is necessary when call is tried with A only in Ubigate
iBG3026 B.
The only exception of above examples is the case sharing the same Ubigate
iBG3026 by two POTS dial peer like the Figure 33.7. In that case, it is not
necessarily to configure VoIP dial peer.
This case is similar to hairpinning which is the status of being detoured to
PSTN after call bound to packet network becomes the impossible condition in
terms of packet network.
Figure 33.7 Communication Between Dial Peers Sharing the Same Ubigate
iBG3026
Configuring POTS Dial Peers
To configure POTS dial peer, the following should be done.
Assign dial peer with the tag number only.
Determine telephone number of termination and number domain.
Assign voice port where call occurs.
IP Network
iBG3026
1/0/0
1/0/0
Source
Destination
4000
4001
dial-peer voioe pots 1
destination-pattern 4000
port1/0/0
dial-peer voioe pots 3
destination-pattern 4001
port1/0/0