Samsung Ubigate iBG3026, Руководство по настройке

Страница: 567 / 718

Ubigate iBG3026 Configuration Guide/Ed.00
© SAMSUNG Electronics Co., Ltd.
525
Timing Settings
To change timing parameters, use the following commands as appropriate, in
voice-port configuration mode.
Step Command Purpose
1 voice-port slot/sub-
slot/port:ds0-group-
no
To set up the attribute values of created ds0-
group, enter voice-port configuration mode.
2 timing clear-wait
milliseconds
(E & M only) Specifies the minimum amount of
time between the inactive seizure signal and
clearing of the call. Valid entries for the
milliseconds argument are from 200 to 2000
milliseconds. The default is 400.
3 timing delay-duration
milliseconds (E & M only) Specifies the delay signal duration for
delay-dial signaling in milliseconds. Valid entries
are from 100 to 5000. The default is 2000.
4 timing delay-start
milliseconds
(E & M only) Specifies minimum delay time, in
milliseconds, from outgoing seizure to outdial
address. Valid entries are from 20 to 2000.
The default is 300.
5 timing dialout-delay
milliseconds
Specifies dialout delay, in milliseconds, for the
sending digit or cut-through on an FXO trunk or
an E & M immediate trunk. Valid entries are
from 100 to 5000. The default is 300.
6 timing digit
milliseconds
Specifies the DTMF digit signal duration in
milliseconds. Valid entries are from 50 to 100.
The default is 100.
7 timing guard-out
milliseconds
(FXO ports only) Specifies the duration in
milliseconds of the guard-out period that
prevents this port from seizing a remote FXS
port before the remote port detects a
disconnect signal. The range is from 300 to
3000. The default is 2000.
8 timing hookflash-out
milliseconds
Specifies the duration, in milliseconds, of the
hookflash. Valid entries are from 50 to 500.
The default is 300.