Samsung Ubigate iBG3026, Руководство по настройке

Страница: 533 / 718

Ubigate iBG3026 Configuration Guide/Ed.00
© SAMSUNG Electronics Co., Ltd.
491
Network Diagram
Figure 31.3 E1-R2 Network Diagram
Configure E1 Trunk
This section shows the process of configuring physical layer of E1 trunk.
Configuring E1 Trunk Settings
To make a E1 connection with a neighboring equipment interwoking on the
PSTN, the configuration should be set up to a characteristic specific to E1 trunk
line. Such configuration is made typically in
module configuration mode.
To configure E1 R2, do the following steps:
1.
Set up the E1 trunk that connects to the private automatic branch
exchange(PBX) or switch.
2.
Ensure that the framing and linecoding of the E1 are properly set.
3.
For E1 framing, choose either CRC or non-CRC .
4
For E1 linecoding, choose either HDB3 or AMI .
5.
For the E1 clock source, choose either internal or line . Keep in mind
that different PBXs have different requirements on the clock source.
Configuration of clock source is only used in module command.
6.
Configure line signaling and interregister signaling for R2.
7.
Customize the configuration with the cas-custom command.
PSTN IP
SIP, H.323 E1 R2