Samson TROVIS 6495-2, Монтаж и эксплуатация

Страница: 112 / 186

16-2 EB 6495-2 EN
Annex A (configuration guide)
16.2 Configuration list · Functions and parameters
Information on the configuration list
Some functions and parameters can only be selected after certain initial settings have been
made beforehand. The initial settings required are specified in angle brackets in the follow -
ing list. A comma represents “and” and a slash represents “or” in the following list.
Example: < M . 1-5/-6, I.3.50 >: Either the configuration M.1-5 and I.3.50 or the configu -
ration M.1-6 and I.3.50 must initially be set.
M Control mode
NOTICE!
Changing the control mode causes the controller to be reset to its default settings.
Default setting Setting
M.1 Control mode M.1.1-1
-1 1x Fixed set point/follow-up control
-2
Ratio control
-3
Cascade control
-4
Override control
-5
2x Fixed set point/follow-up control
-6 Ratio c Controller
I Input
I.1 Analog input AI1 Default
setting
Setting
I.1.1 Input signal I.1.1-6
-1 4–20 mA <both DIP switches on right: mA/V>
-2
0–20 mA <both DIP switches on right: mA/V>
-3
0–10 V <both DIP switches on right: mA/V>
-4
2–10 V <both DIP switches on right: mA/V>
-5
Via interface
-6 Pt 100 <both DIP switches on left: Pt 100/Pt 1000>
-7 Pt 1000 <both DIP switches on left: Pt 100/Pt 1000>
AI1.MIN Lower measuring range value [–999.0…9999.0] 0.0
AI1.MAX Upper measuring range value [–999.0…9999.0] 100.0
AI1.K1 Initial value <I.1.1-5> · Default value
<I.1.5-2>
[–999.0…9999.0] 0.0