EB 5573 EN
29
Manual mode
4 Manual mode
Switch to manual mode to configure all outputs (see section 12).
Risk of damage of the heating circuit through low temperatures.
The frost protection does not function when the controller is in manual mode.
Proceed as follows:
1.
Turn the rotary switch to (manual level).
2.
Select output depending on the control circuit [
q
]:
POS_
Correction value adjusted in percent
UP_
Switching of the circulation pump (heating)
SLP
Switching of the storage tank charging pump
TLP
Switching of the heat exchanger charging pump
CP
Switching of the solar circuit pump
ZP
Switching of the circulation pump (DHW)
3. Confirm output [
Û
].
The reading blinks.
4.
Change the positioning value/switching state [
q
].
5. Confirm change [
Û
].
The modified values remain active as long as the controller is in manual mode.
6. Turn the rotary switch back to normal switch setting (information level).
The manual mode is deactivated.
The outputs of the controller are not affected by merely turning the rotary switch to (manu
-
al level). The outputs are only changed by entering or changing the positioning values or
switching states.
NOTICE
!
Note
