Samson 3730-4, Оригинальное руководство пользователя

Страница: 86 / 128

86 EB 8384-4 EN
Code list
Code
no.
Parameter – Readings/
values [default setting]
Description
5* Nominal range
mm or angle °, ESC
Nominal valve travel or opening angle must be entered for nominal
(NOM) or substitute (SUb) initialization.
The possible adjustment range depends on the pin position from the
table for Code 4.
Code 5 is generally locked until Code 4 is set to No, i.e. after a pin
position has been entered, Code 5 can be configured.
Indicates maximum travel/angle reached during initialization after
initialization has been successfully completed.
6* Init mode
[MAX] Maximum range
NOM Nominal range
MAN Manual setting
SUb Emergency mode
ZP
Zero calibration
ESC Stop
Select the initialization mode
MAX: Travel/angle of the closure member from the CLOSED posi
-
tion to the opposite stop in the actuator.
NOM: Travel/angle of the closure member measured from the
CLOSED position to the indicated OPEN position.
MAN: Manually selected range
SUb:
Substitute calibration (without initialization)
7* w/x
[
ää
] Increasing/increas -
ing
äæ
Increasing/decreas -
ing
ESC
Direction of action of the set point w in relation to the travel/angle x
Automatic adaptation:
AIR TO
OPEN:
On completing initialization, the direction of action remains
increasing/ increasing (
ää
). A globe valve opens as the set
point increases.
AIR TO
CLOSE:
On completing initialization, the direction of action changes
to increasing/decreasing (
äæ
). A globe valve closes as the
set point increases.
8* Travel/angle range start
(lower x-range value)
[0.0] to 80.0 % of the
nominal range, ESC
Note: Specified in mm or
angle ° provided Code 4 is
activated.
Lower range value for travel/angle in nominal or operating range
The operating range is the actual travel/angle of the valve and is
limited by the lower travel/angle range value (Code 8) and the up -
per travel/angle range value (Code 9).
Usually, the operating range and the nominal range are identical.
The nominal range can be limited to the operating range by the low-
er and upper x-range values. The value is displayed or must be en-
tered.
The characteristic is adapted. See also the example in Code 9.