Sampo Rosenlew Comia c4, Инструкция

Страница: 63 / 141

– 61 –
L48a
L48b
L48c
Straw chopper with the guide plate
The straw chopper is powered directly by the engine
by means of a separate belt drive.
The straw chopper will always switch on as the thresh-
ing mechanism is started if the two locking pins A
¿ g.
L48a on the straw chopper shaft are are pushed in.
When the locking pins are pulled out, straw chopper
shaft does not rotate.
The control lever is on the rear right. The straw is
guided to the chopper with the plate in position B. In
position A unchopped straw is guided onto the
¿ eld.
Fig. L48b.
The locking pins may be pushed in even if unchopped
straw is guided onto the
¿ eld. That is if a long straw is
momentarily wanted.
The degree of chopping can be varied by turning
counter knife beam A,
¿ g. L48c. To do this, slacken
screws B on both sides of the chopper, and turn the
counter knife beam into the required position.
With the counter knives at right angles to the rotor
centre, the straw is chopped short and chopping
absorbs more power. With the counter knives down
from the rotor centre, the chaff is cut longer and the
power demand decreases. In their lowest position,
the chopping action is minimal, but for turnip rape and
À ax still suf ¿ cient and recommended.
CHAFF SPREADER Spreads the Chaff
(YHQO\RQWKH)LHOG
The specification of the combine may include a chaff
spreader. The spreader will switch on whenever the
threshing mechanism is running.
The spreader is fastened behind the shaker shoe with
joints. It is turned to the front in its working position.
The rear position is needed while servicing the sieves.