Sampo Rosenlew Comia c4, Инструкция

Страница: 107 / 141

– 105 –
P58
P60
P61
Removing a GIB KEY with a Tool
To keep a gib key in good condition for re-use, use tool
set R116007 to remove it,
¿ g. P58.
5HPRYLQJDQG5H¿WWLQJRID%HDULQJ/RFNHG
with an ECCENTRIC RING
A
Removing:
Slacken the grub screw in the locking ring and open the
eccentric ring by hitting the ring in the opposite direction
of shaft rotation with a mandrel.
Unscrew the
À ange locking screws, remove the outer
À ange and pull the bearing off the shaft.
B
Re ¿ tting:
Fit the inner bearing À ange.
Fit the bearing, locking ring and outer bearing À ange. Fit
the fastening screws of the À anges and tighten by hand.
Check the shaft position and tighten the À ange screws.
Lock the locking ring in the direction of shaft rotation by
hitting it with a mandrel.
Lock the grub screw on the locking ring.
Correct Direction of the SPRING COTTER
NOTCH
Note the position of the cotter notch in regard to the load
direction,
¿ g. P61.
Some joints have two cotters within each other in which
case the notches face each other.