Sampo Rosenlew Comia c4, Инструкция

Страница: 130 / 141

– 128 –
RECOMMENDED TOOLS AND ACCESSORIES
For do-it-yourself maintenance it is necessary to replenish the tools supplied with the combine with the special
tools mentioned under Maintenance as well as with the fork, ring and socket wrench kits, observing the wrench
gap table below and the wrench gaps of 16, 17.5 and 27 mm for the hose and pipe couplings.
Recommended Accessories
For the Cutter Bar
‡ Knife sections 25 pcs
‡ Knife section screws 50
‡ Fingers 2 ”
‡ Knife holders 2 ”
For the Table Auger:
‡ Fingers 4 pcs
‡ Finger bearings 4 ”
‡ Bearing holders 2 ”
‡
For the Reel:
‡ Plastic tines 5 pcs
General Parts
‡ Hexagonal screws M6-M12, the most common
lengths of 16-40 mm, strength class minimum 8.8.
‡ Hexagonal nuts M6-M12, strength class 8.
‡ A few lock nuts.
‡ Washers and spring washers, 6.5-13 mm.
‡ Plate screws 4.8, lengths 9.5-19 mm.
‡ Split cotters 3x20 and 5x30 mm.
‡ Wire cotters 2.5x50 mm.
‡ Spring cotters, 3-8 mm, lengths 20-50 mm.
‡ Circlip cotters 10 mm.
‡ Grease nipples 6 mm and 1 8”, straight and angled.
‡ Additional loops for chains.
‡ Fuses 7.5, 15 and 25 A.
SCREW JOINTS
It is important to tighten the screw joints into the correct tightening torque. Wrench gaps and torque for the screws:
Screw
Wrench Torque for screws
size gap mm of 8.8 strength class
M 6
10 11 Nm
M 8 13 25
M 10 17 47
M 12 19 78
M 14 22 120
M 16 24 180
M 20 30 335
Note! Torque for
¿ xing screws in the wheels:
Front wheels
M18 screws 350 Nm (Grease lubricated hubs)
M22 600 (Oil-bathed hubs)
Rear wheels M16 180 ”
M22 500 (4WD)