Index revision : A
14
7118
4. Technical characteristics
4.1. General characteristics of the guns
120
200
Type of spray
Flat
Original head assembled
09
Maximum incoming paint pressure
120 bar
200 bar
Incoming compressed air pressure
6 bar ± 1 bar
Min/max ambient temperature
0°C - 40°C
Maximum water flow rate
See table below
Spray width at 25 cm
See table below
Air flow rate, in Nm
3
/h
10.3-25.2
Acoustic pressure
90 dB(A)
AFNOR Cup No. 4 suggested paint viscosity
20 s to 120 s
Space requirements
305 x 220 x 52
Mass (without either the hose or the cable)
595 g
Output voltage
60 kV maximum [+0 kV; -1.5 kV] (adjustable on GNM 6080)
Output current
80
μ
A maximum
Output current in a short-circuit
< 20
μ
A
Input voltage of the high-voltage cascade
45 V AC maximum
Input current of the high-voltage cascade
300
mA maximum
Air coupling
1/4 NPS - F
Paint coupling
1/2 JIC - F
Electrical functions available on the gun
High-voltage On / Off switch
Electrical / pneumatic connector
The electro-pneumatic connector, secured by means of two screws.
MUST NEVER BE DISCONNECTED IN AN EXPLOSIVE
ATMOSPHERE
Maximum operating altitude
2,000 m
Maximum
relative humidity
of 80% for
temperatures of up to 31°C, then linear
decrease until 50% relative humidity at
40°C
Maximum of 80% without condensation
Surface temperature
T6
Protection index
IP 20
Transport / Storage
Time spent in storage
Max. 2 years
Min/max storage temperature
-10°C + 45°C
Humidity
95% without condensation
Min. pressure
750 mbar
Exposure to UV rays
Stored out of direct light
Exposure to ionising radiation
Not accepted
