Index revision : A
7
7118
2. Health and safety guidelines
WARNING : This equipment may be hazardous if it is not used, disassembled and reassembled
in accordance with the rules indicated in this manual and in any applicable Euro-
pean Standard or national safety regulations.
The warning sign summarising the safety rules (procedures and precautions) of the
present user’s manual must be placed in a visible location within the zone of the
coating product spraying station.
WARNING : The good working order of this equipment is only under warranty provided use of
original spare parts distributed by ”
SAMES KREMLIN
” company.
2.1. Regulations
The
Nanogun Airmix
®
H
2
O
gun must always be used under the set of conditions required by cur-
rent standards and rules as regards the application of paints and varnishes
(see the Standards
and Directive EN 50.053 Directive, Part 1 ISO 12100, EN 1953 and 99/92/CE).
In
Canada
, the installation must comply with the Code
"
C22.1 Canadian Electrical Code, Part
I, Safety Standard for Electrical Installations
".
In the
United States
, the installation must comply with the Code
"
NFPA 70: National Electrical
Code
"
.
The
Nanogun Airmix
®
H
2
O
gun has been designed to operate within a 2nd-degree pollution
environment, as defined according to the Standard IEC-664-1.
2nd-degree pollution:
Under normal use conditions, only non-conductive type pollution arises.
On a temporary basis, conduction caused by condensation may arise.
WARNING :
Before using the Nanogun Airmix
®
H
2
O gun, be sure that all operators
•
have received preliminary training by the
SAMES KREMLIN
,
or by the Distributors it has
certified for this purpose.
•
have read and understood the user’s manual as well as all installation and use rules listed
below.
It is incumbent upon the Operators’ Workshop Manager to ensure and verify that all operators
have read and understood the user’s manuals relative to peripheral electrical devices present
within the spraying perimeter.
2.2. Installation rules
• The hand-held electrostatic projection equipment can only be used in designated pro-
jection spots in accordance with Standard EN 12215 or under equivalent ventilation con-
ditions.
• Install the equipment
away from any explosive zone
.
• Servo-control the control module start-up to the “on” position of the booth’s suction fan.
• Correctly connect the control module to the installation’s ground terminal.
• Connect the pump and the paint tank by means of an equipotential connection.
• Connect all metal parts of the installation (paint pumps, containers, stools, spin coaters,
etc.), which positioned within three meters of the gun to the ground.
• Keep the spray zone clean and free of all unnecessary components.
