Doc.-ID: 200514-PT08BA-SS-ExCam XPT-Q6075_en_rev.00.docx, Page 21 of 28
5.3.5
Fusing
PoE+ power supply requires no fuses.
The power supply fusing depends on the cable cross-section and length.
Attention!
Recommendation for fusing relates to 60W@24VDC at 100meters 1.5
mm
2
Attention!
When the heating switches on, there are high current peaks! Use slow-
blow fuses.
Attention!
Please pay attention to the national and international regulations re-
garding selectivity and line protection.
Potential/
Wire no.
Colour
(IEC60757)
Conductor
Voltage
Maximum power consumption/fus-
ing:
L+ / 1
BK
1.5mm
2
,
stranded wire
+24 VDC
60 W of continuous power
Fine-wire fuse
(L+) 6000 mA -T- slow-blow
(high inrush load!)
L- / 2
BU
1.5Mm2,
2
,
stranded wire
0 VDC / GND
PE
YE/GN
1.5Mm2,
2
,
stranded wire
PE
Tab. 5-12 Recommendation for fusing
5.3.6
Plug assignment (RJ45)
The data transfer of the ExCam XPT Q6075 series uses a 100 Mbit/s Ethernet connection
(100BASE-TX).
If the cable termination uses a plug, (figure 5.3) it has to be plugged into the associated
slot of the network device. Prior to connecting it to the camera, the network device (PSE)
ca
n already be supplied with power, hence there is no „power ON“ priority which has to be
observed.
Attention!
Use the appropriate RJ45 plug! Check shielding, cross-section and the
outside diameter of the cable!
Attention!
It is imperative to ensure a correct assignment of the individual wires
according to the EIA/TIA-568B"
