204
•
Appendix
Sam4POS 6600/4800II Operators Manual v2.9
Required ECR Program Settings
Consult with your local dealer for programming your terminal.
Device Programming
Device Setting
1.
Go to the Program Mode → Device → Device Setting; Select
EFT
from the device list to assign
the Datacap IPTran-LT or new style PDC device to the appropriate serial port.
2.
Add a
NEW
device if no EFT device already exists.
3.
Select
DATACAP
for the
DEVICE MODEL
choice; press
OK
.
4.
In the
GENERAL
settings, verify the:
•
Device Model is
DATACAP
and
•
Communication Type is
SERIAL
5.
Set/verify the
SERIAL
settings for:
•
COM PORT
(where the Datacap device is connected)
•
BAUD RATE =
19200
•
DATA BITS =
8
•
PARITY =
NONE
•
STOP BIT =
1
•
FLOW CONTROL = NONE
These settings are the same for both, the IPTran-LT and the new style PDC.
Note:
When a TranServer with new style PDC’s is connected to the terminals, the PDC’s are to be
identified as
DATACAP
for the device model in the Device Settings.