Salus PCSol 300, Инструкция по установке и эксплуатации, Страница: 4 / 56

4
1. SAFE INSTALLATION AND USE
The controller is designed only for household
and similar use.
Before installation, service or maintenance
and prior to making any connections, always
disconnect power supply and make sure that the
terminals and electric wires are not energized.
When the controller is switched off using
keyboard or encoder, the controller
terminals are still under dangerous
voltage.
Controller may be used only for its
intended purpose.
It is required to use auxiliary protection
automatics to protect hot water system,
CH system (if any) in case of the
controller or software malfunction
Programmable settings must be selected
suitably to your system type, taking into
account all of its operating conditions.
Wrongful settings may cause the collector
or reservoir malfunction (e.g. collector
overheating, etc.).
Programmed settings may be modified
only by a person who read and understood
this manual.
Use only in heating systems that are set
up in accordance with valid regulations.
Electric system to which the controller is
connected must be protected with a cut-
out device suitable for expected loads.
Never use the controller when its casing is
damaged.
In any case do not alter the controller
components.
The controller has electronic disconnection
for connected devices (operation 2.B
according to PN-EN 60730-1). It means
that at 230V voltage supply the pump
outlets have dangerous voltage, even if
the pumps are not controlled.
Do not allow children access to the
controller.
Before you open casing, first disconnect
power supply from the unit.
The controller must be installed in
accordance with the requirements of EN
60335-1 standard, by qualified and
authorized technician.
Do not install the unit when it is connected
to voltage.
Short circuit in pump output will damage
your unit.
Do not operate the unit when it is
malfunctioning or was repaired by
unauthorized persons.
Do not mount the unit on flammable
materials.